The use of Bricks or Pavers to develop a pathway or patio area complements a home in a way that is unrivaled. In addition, installing a Brick or Paver walkway does not necessarily need a pro.
The secret to installing a Brick or Paver Walkway is to first correctly prepare the area where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the pathway.
When the location has been dug down, 3/4" gravel stone must be laid in and tamped down firmly. The height in between the tamped down sand and the stringline should equate to the thickness of the brick or paver.
Now that you have a steady base, place a 1" pipeline or ledger board the length of the walkway on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install a work on both sides of the prepared location. These strips will function as your pathway border and help to maintain the integrity and shape of the sidewalk. You can get these plastic strip borders at a lot of house improvement shops. The strips ought to be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.
The key to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again assist keep the stability of the pathway.
Inevitably bricks/pavers get more info will need to be cut or split when building the walkway. Unless you wish to purchase or lease a pricey wetsaw, I would recommend purchasing an easy brick/paver splitter. It is generally a chisel with a wide end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. Then using a hammer strike the butt end of the sculpt securely. You may require to do this a couple of times. You might also wish to turn the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within one or 2 more info strikes the brick/paver ought to break easily. If your pathway has curves you will require to buy/rent a wetsaw.
After setting up the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and pack down securely.
Spread stone dust over the new walkway and sweep into the cracks. This will finish the interlocking of the bricks and assist to remove any weed development.
In addition, setting up a Brick or Paver sidewalk does not necessarily need a pro. The secret to setting up a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, place a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and assistance to maintain the stability and shape of the pathway. Undoubtedly bricks/pavers will require to be cut or divided when developing the pathway.